靜電粉末涂裝應注意高壓靜電安全！！ 

　靜電粉末涂裝應注意高壓靜電的安全靜電粉末涂裝應注意高壓靜電的安全粉末涂料的主要涂裝方法是靜電粉末涂裝法，所用靜電是高壓靜電，電壓在30～100kv，電壓很高，但電流很小。一般損傷人體器官的電流為5mA，而噴槍的電流為0.7mA，對人體是安全的。有些人對高壓靜電感應和敏感，當觸到身上有明顯刺激作用，受驚嚇會引起二次災害和事故。為了避免和防止這類事故的發身，應該注意一下問題。 

　　噴涂時應選用高壓發生器安裝在噴槍體內的噴槍。不宜采用高壓電纜連接噴槍和高壓發生器的噴槍，若必須使用這種高壓電纜噴槍時，一定要采取措施，防止電纜漏電和放電問題，以免造成事故。 

　　使用電壓應當控制在9wv以下，超過這個電壓會對人體的家抗不利。另外短路電流要控制在0.7?A以下。 

　　為了盡快消除靜電荷，手工噴涂時，噴槍使用后立即接觸接地導體，及時釋放殘留電荷，同時人體與地面不要絕緣，及時消除人體上的電荷。 

　　被涂物和噴槍口之間距離不要太近，要保持10cm以上，防止短路產生電火花